Did You Actually Test Every Heat Strip - Short #311

0:00-14:42

In this short podcast episode, Bryan talks about electric heat and whether your service or maintenance procedure actually allows you to test every heat strip. In our climate, we use electric heat as auxiliary heat (as opposed to a furnace in a dual-fuel setup). There is also some information about maintenance procedures, blower interlocks and relays, and math to determine amperage. If you put the thermostat in heat and the blower runs, you only prove that the heat pump is heating; it doesn't tell you which electrical circuit is heating, or whether the auxiliary heat is producing heat at all. You can't assume that the last tech left you the correct kit with everything wired up and that it has been wired properly with the correct wire size. Electric heaters in heat pumps usually turn on with a W call from the thermostat or the defrost board. Sometimes, there is a high-voltage interlock with a relay that runs the blower with the electric heat but not the other way around. Older heat strips may also have heat sequencers, which follow a specific sequence and stage on or off over time. We test heat strips by forcing a call for heat, waiting as long as needed, measuring the amperage to make sure it matches the heat kit, making sure the blower comes on, and verifying that the call for heat ends as it's supposed to. Temperature rise may also be a useful measurement.

Publisher

HVAC School - For Techs, By Techs

Link

hvacschool.libsyn.com/did-you-actually-test-every-heat-strip-short-311

Published

November 10, 2026

Duration

15 min

Format

Podcast

Category

Issues · Careers

Source

RSS feed

Host

Bryan Orr

HS

HVAC School - For Techs, By Techs

@hvacschoolfortechsbytechs

#test #heatstrip #short #careers #selfimprovement

The Nile